S2000 LIGHTWEIGHT TUBULAR IMPACT BAR (REAR) V1
Lead Time 3-4 Weeks*
For Racing Purposes Only. This is a direct bolt on replacement for the factory impact beam. Made from seamless .095 DOM tubing and thick steel baseplates (Meets regulations for FD spec and SCCA for cars <2,599lbs. The bars weigh less than half of what the OEM rear impact beam does. (OEM Rear Beam is 12.05lbs, PANESPEED bar is 5.38lbs)
Original Powder Coated Satin Black Finish
Will fit ALL aftermarket and OEM rear bumpers on the market. (spacing from the outermost edge of the bar to the license plate bracket on an OEM AP1 Bumper is roughly 2”, and spacing to the inner part of the bumper cover is 4”~)
Laser cut end plates
Straight tube design provides more clearance with aftermarket diff coolers, trans coolers, and provides a rigid location to mount a rear diffuser, etc.
Lead Time 3-4 Weeks*
For Racing Purposes Only. This is a direct bolt on replacement for the factory impact beam. Made from seamless .095 DOM tubing and thick steel baseplates (Meets regulations for FD spec and SCCA for cars <2,599lbs. The bars weigh less than half of what the OEM rear impact beam does. (OEM Rear Beam is 12.05lbs, PANESPEED bar is 5.38lbs)
Original Powder Coated Satin Black Finish
Will fit ALL aftermarket and OEM rear bumpers on the market. (spacing from the outermost edge of the bar to the license plate bracket on an OEM AP1 Bumper is roughly 2”, and spacing to the inner part of the bumper cover is 4”~)
Laser cut end plates
Straight tube design provides more clearance with aftermarket diff coolers, trans coolers, and provides a rigid location to mount a rear diffuser, etc.
Lead Time 3-4 Weeks*
For Racing Purposes Only. This is a direct bolt on replacement for the factory impact beam. Made from seamless .095 DOM tubing and thick steel baseplates (Meets regulations for FD spec and SCCA for cars <2,599lbs. The bars weigh less than half of what the OEM rear impact beam does. (OEM Rear Beam is 12.05lbs, PANESPEED bar is 5.38lbs)
Original Powder Coated Satin Black Finish
Will fit ALL aftermarket and OEM rear bumpers on the market. (spacing from the outermost edge of the bar to the license plate bracket on an OEM AP1 Bumper is roughly 2”, and spacing to the inner part of the bumper cover is 4”~)
Laser cut end plates
Straight tube design provides more clearance with aftermarket diff coolers, trans coolers, and provides a rigid location to mount a rear diffuser, etc.